Diginet LEDsmart+ MMDM RT Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Dimmer Diginet LEDsmart+ MMDM RT. Diginet LEDsmart+ MMDM RT 12 halaman. Setup functions

B: Setting Minimum Brightness

The minimum brightness level provided by the dimmer can be set to suit specific lamps and/or customer

requirements.

For the majority of lamps a minimum level as low as 0% can be set if required. However, some lamps can become

unstable at low dimming levels, in particular CFL's.

If lamps become unstable at low dimming levels, they typically flicker or pulse on/off. The dimmer allows the

minimum brightness to be set to a level above the point at which the lamp flickers/pulses.

Step 1

Enter into the dimmer Setup Mode - See PART A

Step 2

Click the dimmer rotary shaft twice

Step 3

LED will blink 2 times

Note: To cancel/exit do nothing for 30 seconds

Note: If more than one dimmer is connected to the same load, all dimmers connected

to this load will now blink 2 times

Step 4

Adjust dial to required MINIMUM brightness level

Note: If more than one dimmer is connected in parallel (see pages 5-7), wait for 3

seconds for the other connected dimmer to learn the new minimum level

Note: To cancel/exit do nothing for 30 seconds

Step 5

Click once to save & exit

Note: If more than one LEDsmart

brightness levels only needs to be set in one device. The setting is automatically saved

to all other devices connected in parallel

device is connected in parallel, the minimum

Setup Functions - Rotary Dimmer/Switch