Diginet DGEMSR360P1 Panduan Pengguna dan Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Instalasi untuk Sensor Keamanan Diginet DGEMSR360P1. Diginet DGEMSR360P1 16 halaman. Recessed flush mount 360 pir presence sensor

Halaman Cetak
DIGINET ENERGY MANAGEMENT
8.

Power Surges

The presence sensor control module should only be connected to a mains supply within the range stated in
Section 10. Nominal fluctuations in mains supply voltage will have no effect on the control module as the dc
output to the sensor head remains stable. However induced voltages or surges may occur on electrical circuits in
an installation as a result of excessive voltages from external influences which can damage electronic equipment.
It is strongly recommended that the electrical installation be fitted with suitable over-voltage protection at the
electrical switchboard to avoid these situations.
9.

Insulation Resistance Testing

Generally it is not a requirement to perform an IR test on the PIR control module. In the event it is required, the
PIR control module cables must be disconnected from the mains supply to conduct the test and then
reconnected.
10.

Product Specifications

Parameter
Input voltage (control/power module)
Input current (control/power module)
Frequency
Output rated current (control/power module)
Output voltage (sensor head)
Output current (sensor head)
Isolation
Remote Override
Start-up time
Ambient operating temperature
Ambient storage temperature
Humidity
Sensor head cable
Mains supply terminals (including override)
Conductor strip length
Ingress protection
Material
Weight
Ceiling cut-out
Dimensions
Compliance
Diginet Control Systems Pty Ltd
Recessed Flush Mount 360
DGEMSR360P1
(1 channel model)
220 – 240 ac
2mA (Relay Off)
11mA (Relay ON)
50/60Hz
16A per relay channel
12V dc nominal
8mA nominal under normal detection with a single sensor.
≥3.75kV ac (Mains/Sensor Head) / SELV
A maximum of 10 remote switches can be connected with up to
20m of cable on the same circuit.
45 sec initialisation (5 mins for full sensitivity)
-10°C to +45°C
-10°C to +60°C
10% – 95% RH, non-condensing
Factory fitted – 0.45m
Maximum custom – 1.0m
2
Screwed – 2 x 1.5mm
6-7mm
IP20
Flame retardant polycarbonate
178g
52mm diameter
Refer to Figures 12 and 13
o
PIR Presence Sensor
Specification
DGEMSR360P2
(2 channel model)
2mA (Relay Off)
20mA (Relays ON)
2
or 1 x 2.5mm
192g
Page 11 of 16