Diginet DGEMSR360P2 Panduan Pengguna dan Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna dan Instalasi untuk Sensor Keamanan Diginet DGEMSR360P2. Diginet DGEMSR360P2 16 halaman. Recessed flush mount 360 pir presence sensor

Halaman Cetak

DIGINET ENERGY MANAGEMENT

Operation and Configuration

Upon power-up the sensor performs an initialisation which will take approximately 45 secs. During this period the

relay will close and open forcing the connected load to turn on and off. Once the initialisation has completed,

normal operation commences at which full sensitivity is reached after a period of 5 mins.

When the presence sensor is powered and functional, green and red LEDs within the sensor head will indicate

mode/operation as defined in Table 2.

Table 2 – LED indicators for each of the operational conditions

Mode

Normal Operation

Walk Test Mode*

*Override mode is disabled during walk test mode.

The time delay and light level threshold settings are easily configured after installation by using the patented push

in-pop out mechanism as detailed in Figures 7 and 8.

Figure 7 - Press gently on the lens until a click is heard then release to access sensor adjustment sliders

Figure 8 - Press gently on the head until click is heard to return to normal operating position.

As shown in Figure 8, the adjustable sliders for time delay and light level threshold are accessed when the sensor

head is in the out position. Tables 3 and 4 detail the parameters for the time delay and ambient light level

adjustable settings.

Diginet Control Systems Pty Ltd

LED Indicator

Green LED OFF

Green LED ON

Red LED ON

Green LED "Flashing"

Red LED "Flashing"

Recessed Flush Mount 360

Condition

Ambient light below threshold setting

Ambient light above threshold setting

Manual override activated

Ambient light above threshold setting

Movement detected

PIR Presence Sensor

Page 8 of 16