Cisco 1548M MICRO SWITCH Panduan Memulai Cepat - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Cisco 1548M MICRO SWITCH. Cisco 1548M MICRO SWITCH 8 halaman. 10/100 cabling and start up
Halaman Cetak
Connect the Switch to Other Network
Devices (continued)
Power outlet
RJ-45-to-RJ-45
rollover console cable
Connect the Console Cable
Make sure console port settings of the
1
switch match the settings of the
terminal, PC, or laptop. The default
settings of the switch console port are
9600 baud, 8 data bits, 1 stop bit,
no parity, and no flow control.
Connect the rollover console cable to
2
the CONSOLE port on the switch.
Connect the other end of the rollover
3
cable to your terminal, PC, or laptop
(if necessary, use an appropriate
adapter, such as the supplied
RJ-45-to-DB-9 adapter).
From your terminal, PC, or laptop, start
4
the terminal emulation program.
C is co 15
48 M
1x
2x
10/1 00
3x
RAT ING
4x
100 -127
/200 -240
100B T-ON
0.3A /
V~
0.2 50/6
/ 10B T-OF
0 Hz
1
F
2 3 4
5 6 7
1 2 3
8
4 5 6
CON SOLE
7 8
FDU P-O
N / HDU
P-O FF
5x
6x
7x
8x
Console port
(RJ-45)
RJ-45-to-DB-9
adapter (supplied)
Power Up the Switch
Connect one end of the power cord to
1
the switch and the other end to a power
source.
Wait approximately 2 minutes for the
2
switch to complete its power-on self-test
(POST) and to discover the network.
After POST completes, the Continue
with configuration dialog? prompt
appears on the management station.
You can then follow the prompts to
assign IP information to the switch.
3