Cisco 200E Series Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Beralih Cisco 200E Series. Cisco 200E Series 13 halaman. Advanced smart switches

Halaman Cetak
When the switch is using the factory default IP address, the System LED
flashes continuously. When the switch is using a DHCP-assigned IP
address or an administrator-configured static IP address, the System LED
is on solid.
If the advanced smart switch IP address is changed, either by a
N
OTE
DHCP server or manually, your access to the advanced smart switch will
be lost and you must enter the new IP address to use the web-based
interface.
Use the Web-Based Interface
To configure the advanced smart switch:
Power on the computer and the switch.
S
1
TEP
Connect the computer to the switch by connecting them directly
S
2
TEP
with an Ethernet cable, by connecting them both to the same IP
subnetwork, or through a router if they are on different
subnetworks.
Set up the IP configuration on your computer.
S
3
TEP
a.
If the switch is using the default static IP address of
192.168.1.254, you must chose an IP address in the range of
192. 1 68. 1 .2—192. 1 68. 1 .253 that is not already in use.
b. If the IP addresses will be assigned by DHCP, make sure your
DHCP server is running and can be reached from the switch
and the computer. You may need to disconnect and reconnect
the devices for them to discover their new IP addresses from
the DHCP server.
Details on how to change the IP address on your computer
N
OTE
depend upon the type of architecture and operating system you are
using. Use your computers local Help and Support functionality and
search for "IP Addressing".
Open a Web browser window. If you are prompted to install an
S
4
TEP
Active-X plug-in when connecting to the device, follow the
prompts to accept the plug-in.
Enter the switch IP address in the address bar and press Enter. For
S
5
TEP
example, http://192.168.1.254.
The Advanced Smart Switch Login Page displays.
Enter the default login information:
S
6
TEP
The default username is cisco, and the default password is cisco.
If this is the first time that you have logged on with the default
S
7
TEP
username and password, the
200E Series Advanced Smart Switches
Change Password Page
opens.
5