Cisco 2960-C Panduan Instalasi - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Cisco 2960-C. Cisco 2960-C 37 halaman.
Juga untuk Cisco 2960-C: Panduan Memulai (25 halaman)

Halaman Cetak
Cisco 2960-C Panduan Instalasi
Chapter 2
Switch Installation
(Optional) To attach the cable guard to the desk or wall, use a 0.144-inch (3.7 mm) or a #27 drill bit to
Step 5
drill 1/2-inch (12.7 mm) holes at each of the two mounting locations. Insert the supplied 0.5 in.
(12.7 mm) number-8 Phillips wood screws and tighten them as shown in
Figure 2-33
1

After Installing the Switch

1.
2.
3.
For configuration instructions about using the CLI setup program, go to
Switch with the CLI Setup Program."

Installing SFP Modules

When installing SFP modules, observe these guidelines:
•
•
OL-23803-02
Securing the Cable Guard to the Desk
Number-8 Phillips wood screws
Power on the switch. See the
Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the switch getting started guide
for instructions.
Connect to the ports. See the
complete the installation.
Removing and installing an SFP module can shorten its useful life. Do not remove and insert any
module more often than is absolutely necessary.
To prevent ESD damage, follow your normal board and component handling procedures when
connecting cables to the switch and other devices.
1
2
Desk or shelf
"Verifying Switch Operation" section on page
"Connecting Devices to the Ethernet Ports" section on page 2-33
Catalyst 3560-C and 2960-C Switch Hardware Installation Guide
After Installing the Switch
Figure
2-33.
1
2
2-5.
Appendix C, "Configuring the
2-31
to