Cisco 2975 - Catalyst LAN Base Switch Panduan Memulai - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Beralih Cisco 2975 - Catalyst LAN Base Switch. Cisco 2975 - Catalyst LAN Base Switch 17 halaman. Stackable switch
Juga untuk Cisco 2975 - Catalyst LAN Base Switch: Buletin Produk (2 halaman), Lembar data (14 halaman), Brosur (19 halaman)
Halaman Cetak
3
Running Express Setup
When you first set up the switch, you should use Express Setup to enter the initial IP information. Doing this enables the switch
to connect to local routers and the Internet. You can then access the switch through the IP address for further configuration.
You need this equipment to set up the switch:
• A PC with Windows 2000 or XP installed
• A web browser (Internet Explorer 6.0, 7.0, Firefox 1.5, 2.0, Windows Vista OS) with JavaScript enabled
• A straight-through or crossover Category 5 Ethernet cable to connect your PC to the switch
Before running Express Setup, disable any pop-up blockers or proxy settings in your browser software and any wireless client
running on your PC.
During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, change your PC settings before you
begin to temporarily use DHCP.
To run Express Setup:
Make sure that nothing is connected to the switch.
Step 1
Power the switch by connecting the AC power cord to
Step 2
the switch power supply and to a grounded AC outlet.
When the switch powers on, it begins the power-on self-test (POST). During POST, the LEDs blink while tests verify
Step 3
that the switch functions properly.
Wait for the switch to complete POST, which can take several minutes.
Verify that POST has completed by confirming that the SYST LED remains green. If the switch fails POST, the SYST
Step 4
LED turns amber. See the "In Case of Difficulty" section on page 14 if your switch fails POST.
Press and hold the Mode button for 3 seconds. When all
Step 5
of the LEDs above the Mode button turn green, release
the Mode button.
If the LEDs above the Mode button blink after you press the button, release it. Blinking LEDs mean that the switch
Step 6
is already configured and cannot go into Express Setup mode. For more information, see the "Resetting the Switch"
section on page 15.
Verify that the switch is in Express Setup mode. Make sure that all LEDs above the Mode button are green. (On
Step 7
some switch models, the RPS LED remains off.)
Connect a Category 5 Ethernet cable to any Ethernet
Step 8
port on the switch front panel.
Connect the other end of the cable to the Ethernet port
on your PC.
Catal yst 2975
G
Series
PoE-4 8
STA CK
1
CON SOL
STA CK
E
2
DC INPU
TS FOR
REM OTE
POW ER
SPEC IFIED
SUPP LY
IN MAN
UAL
Catal yst 2975
G
Series
PoE-4 8
Cataly st 2975G
Series
PoE-4 8
3