Cisco 3020 - Cisco Catalyst Blade Switch Panduan Instalasi

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 halaman. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Juga untuk Cisco 3020 - Cisco Catalyst Blade Switch: Panduan Memulai (37 halaman), Panduan Memulai (31 halaman), Quickspecs (12 halaman), Catatan Rilis (41 halaman), Catatan Rilis (27 halaman), Catatan Rilis (23 halaman), Catatan Rilis (21 halaman)

Halaman Cetak

Cisco 3020 - Cisco Catalyst Blade Switch Panduan Instalasi

Switch Installation

This chapter provides instructions on how to install your Cisco Catalyst Blade Switch 3020 for HP,

referred to as the switch module, in the HP c-Class BladeSystem enclosure and how to set up and

configure your switch module. The HP c-Class BladeSystem, referred to as the blade server, is a system

that supports up to 16 server modules and up to 8 Ethernet switch modules. The switch module is

installed in one of the enclosure I/O module bays on the rear panel of the server enclosure.

This chapter also describes how to interpret the power-on self-test (POST) that ensures proper operation

and how to make connections to the switch module.

Read the topics and perform the procedures in this order:

•

Preparing for Installation

This section covers these topics:

•

OL-8914-02

Preparing for Installation, page 2-1

HP c-Class BladeSystem Enclosure Architecture, page 2-5

Installing the Switch Module in the Blade Server, page 2-6

Running Express Setup, page 2-9

Installing and Removing SFP Modules, page 2-15

Connecting to the 10/100/1000 Ports, page 2-18

Connecting to SFP Modules, page 2-19

Where to Go Next, page 2-20

Warnings, page 2-2

Installation Guidelines, page 2-3

Verifying Package Contents, page 2-4

C H A P T E R

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-1