Cisco 4506 - Catalyst Switch Ikhtisar - Halaman 45
Jelajahi secara online atau unduh pdf Ikhtisar untuk Beralih Cisco 4506 - Catalyst Switch. Cisco 4506 - Catalyst Switch 46 halaman. Promotional bulletin
Juga untuk Cisco 4506 - Catalyst Switch: Deskripsi (2 halaman), Panduan Cara (2 halaman), Lembar data (23 halaman), Buletin Dukungan Produk (4 halaman), Panduan Tambahan (3 halaman)
Halaman Cetak
Chapter 1
Module Overview and Specifications
Hot-Swapping Feature
78-13267-06
Table 1-3
Switching Module LEDs (continued)
LED
Color/State Description
Port
2
Status
Green
Orange
Flashing
orange
Off
1. Used on the WS-X4232-L3 Ethernet routing module.
2. LEDs labeled 1 through the number of ports on the switching module are the individual port link
LEDs.
Catalyst 4500 series switches allow you to remove and replace switching modules
without powering down the switch. This feature is known as hot swapping.
When you remove or insert a switching module while the switch is operating, the
system does the following:
Scans the backplane for configuration changes.
1.
Initializes all newly inserted switching modules, notes any removed modules,
2.
and places them in the administratively shutdown state.
Places any previously configured interfaces on the switching module back to
3.
the state they were in when they were removed. Any newly inserted interfaces
are put in the administratively shutdown state, as if they were present (but
unconfigured) at boot time. If you insert a similar switching-module type into
a slot, its ports are configured and brought online up to the port count of the
original switching module.
The system runs diagnostic tests on any new interfaces. If the test passes, the
system is operating normally. If the new switching module is faulty, the system
resumes normal operation but places the new module in the "faulty" state.
If the diagnostic test fails, the system crashes, which usually indicates that the
new switching module has a problem and should be removed.
Indicates individual port status.
The port is operational (a signal is detected).
The link has been disabled by software.
The link has been disabled due to a hardware failure.
No signal is detected.
Catalyst 4500 Series Module Installation Guide
Hot-Swapping Feature
1-45