Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi - Halaman 17

Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Beralih Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 halaman. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Juga untuk Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Catatan Instalasi (14 halaman), Panduan Solusi (17 halaman), Catatan Instalasi (46 halaman), Buku Putih (19 halaman), Deskripsi (1 halaman), Buletin Produk (6 halaman), Pemberitahuan (4 halaman), Lembar data (9 halaman), Lembar data (18 halaman), Buku Putih (18 halaman), Panduan Konfigurasi (8 halaman), Catatan Instalasi (28 halaman), Panduan Pemecahan Masalah (11 halaman), Catatan Instalasi (18 halaman), Panduan Pengguna (17 halaman), Manual (19 halaman), Catatan Instalasi (36 halaman)

Halaman Cetak
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Catatan Instalasi
Figure 7
FAN
STATUS
e.
Note
Make sure that the ejector levers are fully closed before tightening the captive installation screws.
This completes the CSM installation procedure.

Verifying the Installation

When you install the CSM into the Catalyst 6500 series switch, the module goes through a boot sequence
that requires no intervention. At the successful conclusion of the boot sequence, the green Status LED
will light and remain on. If the Status LED does not show green, or if it shows a different color, refer to
Table 1 on page 5

Using the CLI

The software interface for the module is the Cisco IOS and the Catalyst operating system command-line
interface accessed through a Telnet connection to the switch or through the switch console interface.
Refer to the Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide and the Catalyst 6500
Series Switch Software Configuration Guide for details.
78-15751-01
Ejector Lever Closure in a Vertical Slot Chassis
All ejector levers flush
with module faceplate
Tighten the two captive installation screws on the module.
to determine the module's status.
Catalyst 6500 Series Switch Content Switching Module Installation Note
Verifying the Installation
17