DigiPos DS-810 Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer DigiPos DS-810. DigiPos DS-810 14 halaman.
Halaman Cetak
3. Control panel and other functions
3-1. Control panel
You can control the basic paper feeding operations of the printer with the button on the control panel.
The indicator lights help you to monitor the printer' s status.
Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also hold down the FEED button to
feed paper continuously.
3-2. Error indicators
This section explains the different patterns signaled by the three LED indicators located on the top
cover of the printer.
PAPER
ERROR
STATUS
RED
RED
Power off
OFF
OFF
Power on
OFF
OFF
On line
OFF
OFF
Cover open
OFF
ON
Paper empty
OFF
ON
Paper near end
ON
OFF
Test mode
OFF
OFF
14
POWER
REMARKS
GREEN
Normal power is not supplied to
OFF
the printer
Normal power is supplied to the
ON
printer
ON
Normal error-free mode
ON
Close cover
ON
Insert new paper roll
ON
Paper is low
ON
Ignored error led
4. Self Test
The self-test lets you know if your printer is operating properly. It checks the control circuits, printer
mechanisms, print quality, ROM version and DIP switch settings.
This test is independent of any other equipment or software.
Running the self test
1. Make sure the printer is turned off and the printer cover is closed properly.
2. While holding down the FEED button, turn on the printer using the switch on the front of
the printer to begin the self-test. The Self Test prints the printer settings and then prints the
following, Cuts the paper, and pauses. (Error LED On)
Self-test printing
Please press the PAPER FEED button.
3. Press the FEED button to continue printing.
The printer prints a pattern using the built-in character set.
4. The self test automatically ends and cuts the paper after printing the following.
*** Completed ***
The printer is ready to receive data as soon as it completes the self-test.
15