Cisco 9000 Series Menginstal

Jelajahi secara online atau unduh pdf Menginstal untuk Beralih Cisco 9000 Series. Cisco 9000 Series 19 halaman.

Installing the Cisco MDS 9148V-K9 Switch

This chapter describes how to install a Cisco MDS 9148V-K9 switch and its components.

Before you install, operate, or service the system, see the

the Cisco MDS 9000 Family

Warning

•

Preinstallation

Cisco MDS 9000 Series Telco and EIA Shelf Bracket

The optional Telco and EIA Shelf Bracket Kit (part number DS-SHELF=) can temporarily or permanently

support the switch during installation. After the front rack-mount brackets are securely attached to the

rack-mounting rails, the shelf bracket can be removed.

The Telco and EIA Shelf Bracket kit supports the following configurations:

• A two-post Telco rack

• A four-post EIA rack

document for important safety information.

This unit is intended for installation in restricted access areas. A restricted access area can be accessed

only through the use of a special tool, lock and key, or other means of security. Statement 1017

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Preinstallation, on page 1

Installing the Switch, on page 6

Grounding the Switch, on page 12

Installing and Removing Components, on page 13

Regulatory Compliance and Safety Information for

Installing the Cisco MDS 9148V-K9 Switch