Cisco 9124 - mds multilayer fabric switch Catatan Rilis - Halaman 16

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Beralih Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 22 halaman. Mds 9000 series
Juga untuk Cisco 9124 - mds multilayer fabric switch: Spesifikasi (2 halaman), Lembar data (9 halaman), Spesifikasi (3 halaman), Panduan Konfigurasi (49 halaman), Catatan Rilis (48 halaman), Catatan Rilis (44 halaman), Catatan Rilis (36 halaman), Catatan Rilis (3 halaman), Catatan Rilis (40 halaman), Manual (16 halaman), Panduan Pemasangan Perangkat Keras (36 halaman)

switch# config terminal

4. Enter the following command to enter the VSAN database:

switch(config)# vsan database

5. Enter the following command to enable the VSAN(s) that contain the Continuous Access

EVA and/or DRM fabric to src-dst-id loadbalancing:

switch(config-vsan-db)# vsan <1-4094> loadbalancing src-dst-id

switch(config-vsan-db)# exit

switch(config)# exit

6. Verify that src-dst-id is enabled for the desired VSAN by entering the following

command:

switch# show vsan <1-4094>

In the following example, VSAN 1 loadbalancing is set to src-id/dst-id

switch# show vsan 1

vsan 1 information

name: vsan1

interoperability mode: default

loadbalancing: src-id/dst-id

operational state: up

7. Type the following to copy the running configuration into the startup configuration:

switch# copy running-config startup-config

Refer to the Cisco MDS 9000 Family Fabric Manager Switch Configuration Guide to set

src-dst-id using Device/Fabric Manager.

Note: The running configuration overwrites the startup configuration.

C-SERIES MDS 9020 FABRIC MANAGEMENT

The C-series MDS 9020 can be managed through the CLI or the Cisco MDS 9000 Family

Fabric/Device Manager tool using Simple Network Management Protocol (SNMP). FabricWare

2.1(3) supports SNMP v1 and SNMP v2. When using Fabric/Device Manager with SNMP v3

enabled, all C-series MDS 9020 configurations must be saved using either the CLI or Device

Manager. In an environment where there is a co-existence of switches running SAN-OS and

FabricWare, Fabric Manager will only save SAN-OS configurations. To save MDS 9020 switch

configurations, the CLI or Device Manager must be used in order to avoid possible inconsistency

or fabric segmentation.

Note: WWPN (FLOGI) information can not be obtained for the MDS 9020 using Device Manager.

CHANGING PORT SPEED ON THE C-SERIES MDS 9020

If required, use the following CLI procedure to change the port speed setting on the C-series

MDS 9020:

state: active

MDS Multilayer Director & Multilayer Fabric Switches Release Notes