Cisco 9134 - MDS Multilayer Fabric Switch Catatan Rilis - Halaman 27

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Beralih Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 44 halaman. Mds 9000 series
Juga untuk Cisco 9134 - MDS Multilayer Fabric Switch: Spesifikasi (3 halaman), Panduan Konfigurasi (49 halaman), Catatan Rilis (48 halaman), Catatan Rilis (22 halaman), Catatan Rilis (3 halaman), Catatan Rilis (40 halaman), Catatan Rilis (10 halaman), Manual (16 halaman), Panduan Pemasangan Perangkat Keras (36 halaman)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Limitations and Restrictions

This section lists the limitations and restrictions for this release.

Upgrading to Recover Loss of Performance Manager Data

You must upgrade to Fabric Manager Release 3.1(x) and then upgrade to a later release of Fabric

Caution

Manager to avoid losing Performance Manager data. If data has been lost, follow the steps below to

recover the data.

Disable Performance Manager interpolation using Fabric Manager Web Client. Uncheck Interpolate

Step 1

missing statistics, then click Apply.

Stop the Fabric Manager Server.

Step 2

Save the data file in the $INSTALL_DIR directory.

Step 3

Move the old RRD file into the $INSTALL_DIR/pm/db directory.

Step 4

Step 5

Run $INSTALL_DIR/bin/pm.bat m.

Step 6

Restart Fabric Manager Server.

Maximum Number of Zones Supported in Interop Mode 4

In interop mode 4, the maximum number of zones that is supported in an active zone set is 2047, due to

limitations in the connected vendor switch.

When IVR is used in interop mode 4, the maximum number of zones supported, including IVR zones,

in the active zone set is 2047.

Upgrading the SAN-OS Software on the MDS 9222i Switch

On an MDS 9222i switch, an upgrade from SAN-OS Release 3.2(x), Release 3.3(1a), or Release 3.3(1c)

to SAN-OS Release 3.3(3) fails when there is an active FC-Redirect configuration (created by Cisco

SME or Cisco DMM applications) on the switch. An active FC-Redirect configuration is defined as:

FC-Redirect configuration for hosts or target connected locally

FC-Redirect configuration created by application running on that switch.

If an upgrade is attempted when an active configurations is present, the switch will go into a disruptive

upgrade.

OL-14116-11

Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(3)

Limitations and Restrictions