Bymat Brushline 1150 RS Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pembersih Bymat Brushline 1150 RS. Bymat Brushline 1150 RS 12 halaman.

Commissioning

Connecting the device:

Connect power cable of the Cleaning and Embossing device to an appropriate power source and turn on

using the on/off switch on the back of the machine.

Connect the black wire to the black terminal connector on the front panel and connect the carbon stamp/

brush at the other end.

Connect the ground cable with the red mark on the red socket on the front panel and attach the

grounding clamp to the work piece.

Do not apply any external voltages to the component to be cleaned!

Do not use in wet areas and protect against moisture and splashes!

Cleaning with the brush

To remove the oxide layer, switch the machine on.

Ensure the brush is fitted with a brush head in good condition.

The brush is connected using the accompanying black ground cable to the black connector of the

machine. The red-marked ground wire must be connected to the work piece via the ground clamp.

Decant a little of the corresponding electrolyte (Electrolyte A / B / C / C Plus or LF) into the wide neck

receptacle provided and immerse the brush. Brush over the oxide layer to be treated until it has all

been removed.

After prolonged use the brush may become too warm. If this occurs, cool it in water bath,

or use a second brush.

Remove the electrolyte of the entire metal surface and neutralize the surface with a cloth soaked

in Neutralizer.

Tips for optimal cleaning

The BYMAT brushes are ideal for cleaning hard-to-reach areas. The short brush makes it easier

to get into sharp corners and around fine detail.

The longer brush is better for cleaning large areas.

To avoid short circuiting the machine, change the brush end before all the brush fibers are

depleted.

Working with chemicals can lead to hazards. It is required to wear an acid apron, tightly

fitting acid resistant goggles and gloves. It is also required to have sufficient extraction/

ventilation around the work piece or to wear a suitable respirator.

Please refer to the safety data sheets of the individual electrolytes.

NOTE: After switch off please wait min. 1 minute before restarting the machine.

User manual Bymat 1120 RS