Accuspray VMX Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Kompresor Udara Accuspray VMX. Accuspray VMX 20 halaman. Portable compressor hvlp system

Gun Adjustments

The fan size is regulated by the fan adjustment knob

located on the side of the gun. With the gun pointed

at your target, turn the knob toward you until it stops.

This is the fully closed position. Turning the knob

away from you increases the fan air.

The fluid is controlled by the needle adjustment

screw located at the rear of the gun. Turning the

knob clockwise (right) will close down the fluid flow,

minimizing needle travel (trigger pull). Turning the

knob counterclockwise (left) will increase the fluid

flow, maximizing needle travel (trigger pull).

With 3 threads of the needle adjustment screw

showing from the gun body (approximately 7

counterclockwise turns from closed) you will have

full needle travel.

Please note that when closing down the needle

adjustment screw, when the needle travel has

stopped, further tightening will damage the needle

tip and will not aid in adjustment.

800-618-6860 or 440-498-9677 Fax: 440-498-9815

- 7 -

V M X

Owners Manual

Hand Gun Use

Spray Technique

Proper spray technique is very important to achieve

a good finish. Always spray at a distance of 6 to 8

inches from your target. Keep the gun parallel to

your target throughout the entire pass. More detailed

spraying can be done with the gun as close as 1

inch from the target. Make sure your wrist remains

firm during each pass.

Trigger your gun only after your pass begins, and

release the trigger before stopping your motion. Do

not angle the gun upward or downward while

spraying. Angled spraying will develop an uneven

paint buildup. Overlap your passes approximately

50% for an even finish. Always be certain to thin

your material with the proper solvent, and to follow

the recommendations of the material's manufacturer.