Cisco ASR-920-4SZ-A Panduan Pemasangan Perangkat Keras - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Beralih Cisco ASR-920-4SZ-A. Cisco ASR-920-4SZ-A 46 halaman. Aggregation services router
Juga untuk Cisco ASR-920-4SZ-A: Panduan Konfigurasi (13 halaman)

Cisco ASR-920-4SZ-A Panduan Pemasangan Perangkat Keras
Safety Guidelines

Standard Warning Statements

To see translations of the warnings that appear in this publication, see the Regulatory Compliance and
Safety Information for the Cisco ASR 920 Series Aggregation Services Router document.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom
of the rack. If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit
in the rack.
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of 158°F (70°C). Statement 1047
Warning
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning
IMPORTANT SAFETY INSTRUCTIONS: This warning symbol means danger. You are in a situation that
could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with
electrical circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device. Statement 1071
Warning
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or buyer
should be aware of this. If this type was sold or purchased by mistake, it should be replaced with a
residential-use type. Statement 294
This is a class A product. In a domestic environment this product may cause radio interference in
Warning
which case the user may be required to take adequate measures. Statement 340
This equipment is in compliance with the essential requirements and other relevant provisions of
Warning
Directive 1999/5/EC. Statement 287
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
2-2
This unit should be mounted at the bottom of the rack if it is the only unit in the rack. When mounting
Statement 1006
Chapter 2
Preparing for Installation
OL-32751-01