Cisco C-series Nexus 5010 Panduan Pemasangan Perangkat Keras - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Beralih Cisco C-series Nexus 5010. Cisco C-series Nexus 5010 19 halaman. Replacing an i/o module nexus 5000 series
Juga untuk Cisco C-series Nexus 5010: Spesifikasi (3 halaman), Lembar data (23 halaman), Catatan Rilis (26 halaman), Catatan Rilis (3 halaman), Manual (11 halaman)
Halaman Cetak
Chapter 4
Replacing Components
Loosen the captive screw on the front of the module.
Step 2
Slide the module part way out of its slot and place your other hand under it to support it.
Step 3
Pull the module fully out of the slot and set it on an antistatic surface or repack it in its packing materials.
Step 4
You are ready to install a replacement module as described in the
the Cisco Nexus 5000 Platform Chassis" section on page
Installing an Expansion Module in the Cisco Nexus 5000 Platform Chassis
To install an expansion module in the Cisco Nexus 5000 Platform chassis, follow these steps:
Step 1
Grasp the handle of the module and place your other hand under the module to support it.
Step 2
Gently slide the module into the opening until you cannot push it any further.
Tighten the captive screw on the front of the module.
Step 3
Figure 4-6
Figure 4-6
Figure 4-7
shows the positioning of an expansion module in the Cisco Nexus 5020 chassis.
Positioning the Module in the Cisco Nexus 5020 Chassis
shows the positioning of an expansion module in the Cisco Nexus 5010 chassis.
"Installing an Expansion Module in
4-7.
Cisco Nexus 5000 Series Hardware Installation Guide
Replacing Expansion Modules
4-7