Cisco C3850-NM-4-1G Menginstal - Halaman 16
Jelajahi secara online atau unduh pdf Menginstal untuk Beralih Cisco C3850-NM-4-1G. Cisco C3850-NM-4-1G 17 halaman.
Juga untuk Cisco C3850-NM-4-1G: Manual (15 halaman)
Halaman Cetak
Removing SFP and SFP+ Modules
Removing SFP and SFP+ Modules
Procedure
Step 1
Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.
Step 2
Disconnect the cable from the SFP/SFP+ module. For reattachment, note which cable connector plug is send
(TX) and which is receive (RX).
Step 3
Insert a dust plug into the optical ports of the SFP/SFP+ module to keep the optical interfaces clean.
Step 4
If the module has a bale-clasp latch, pull the bale out and down to eject the module. If you cannot use your
finger to open the latch, use a small, flat-blade screwdriver or other long, narrow instrument to open it.
Step 5
Grasp the SFP/SFP+ module, and carefully remove it from the slot.
Step 6
Place the SFP/SFP+ module in an antistatic bag or other protective environment.
Finding the Network Module Serial Number
If you contact Cisco Technical Assistance regarding a network module, you need to know its serial number.
Figure 11: Network Module Serial Number Location
Catalyst 3850 Switch Hardware Installation Guide
16
Installing a Network Module
OL-26779-05