Cisco Catalyst 2900 Series Panduan Pemasangan Perangkat Keras - Halaman 28
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Beralih Cisco Catalyst 2900 Series. Cisco Catalyst 2900 Series 47 halaman. Xl modules
Juga untuk Cisco Catalyst 2900 Series: Manual (19 halaman)
Halaman Cetak
Connecting to Module Ports
Warning
Warning
Step 4
Connecting to Module Ports
Note
Catalyst 2900 Series XL Modules Hardware Installation Guide
2-6
Class 1 laser product.
Avoid exposure to the laser beam.
When you are ready to attach the network interface fiber-optic cable, remove the
plug from the GBIC, and save it for future use.
Insert a connector according to the type of module (100BaseFX,
10/100/1000BaseT, or 1000BaseX), as follows:
RJ-45 connector (10/100 and 1000BaseT modules)
•
Insert the RJ-45 connector until it snaps into place, as shown in Figure 2-3.
Fiber-optic port (100BaseFX and 1000BaseX SC modules)
•
Remove the rubber plugs from the fiber-optic port on the module and store
them for future use. Insert the connector in the fiber-optic receptacle, as
shown in Figure 2-5.
The port status LED is amber while Spanning Tree Protocol
discovers the topology and searches for loops. This takes about
30 seconds. The port status LED then turns green.
Chapter 2
Installation
78-5912-03