Cisco Catalyst 2960-CX Manual - Halaman 3
Jelajahi secara online atau unduh pdf Manual untuk Beralih Cisco Catalyst 2960-CX. Cisco Catalyst 2960-CX 24 halaman.
Juga untuk Cisco Catalyst 2960-CX: Ikhtisar Produk (15 halaman)
Halaman Cetak
- 1. Table of Contents
- 2. Finding Feature Information
- 3. Prerequisites for Switch Stacks
- 4. Restrictions for Switch Stacks
- 5. Information about Switch Stacks
- 6. How to Configure a Switch Stack
- 7. Troubleshooting the Switch Stack
- 8. Monitoring the Device Stack
- 9. Configuration Examples for Switch Stacks
- 10. Additional References for Switch Stacks
Managing Switch Stacks
Figure 1: Creating a Switch Stack from Two Standalone Switches
Figure 2: Adding a Standalone Switch to a Switch Stack
Changes to Switch Stack Membership
If you replace a stack member with an identical model, the new switch functions with exactly the same
configuration as the replaced switch, assuming that the new switch (referred to as the provisioned switch) is
using the same member number as the replaced switch.
The operation of the switch stack continues uninterrupted during membership changes unless you remove the
stack master or you add powered-on standalone switches or switch stacks.
• Adding powered-on switches (merging) causes the stack masters of the merging switch stacks to elect a
• Removing powered-on stack members causes the switch stack to divide (partition) into two or more
stack master from among themselves. The reelected stack master retains its role and configuration as do
its stack members. All remaining switches, including the former stack masters, reload and join the switch
stack as stack members. They change their stack member numbers to the lowest available numbers and
use the stack configuration of the reelected stack master.
switch stacks, each with the same configuration. This can cause:
Changes to Switch Stack Membership
Managing Switch Stacks
3