FIBARO ROLLER SHUTTER 3 Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Pengontrol FIBARO ROLLER SHUTTER 3. FIBARO ROLLER SHUTTER 3 18 halaman.

The parameter is irrelevant for other modes.

Size: 1 Byte, Default Value: 1

Setting

slats return to previously set position only in case of the main controller operation.

slats return to previously set position in case of the main controller operation,

momentary switch operation, or when the limit switch is reached.

slats return to previously set position in case of the main controller operation,

momentary switch operation, when the limit switch is reached or after receiving the

Switch Multilevel Stop control frame

Parameter 154: Delay motor stop after reaching end switch

For blinds (parameter 151 set to 1, 2, 5 or 6) the parameter determines the time after which the

motor will be stopped after end switch contacts are closed.

For gates (parameter 151 set to 3 or 4) the parameter determines the time after which the gate

will start closing automatically if S2 contacts are opened (if set to 0, gate will not close).

Size: 2 Byte, Default Value: 10

Setting

Description

0 - 60 (0 – 60s) – time

Parameter 155: Motor operation detection

Power threshold to be interpreted as reaching a limit switch.

Size: 2 Byte, Default Value: 10

Setting

reaching a limit switch will not be detected

1 - 255 report interval in watt

Parameter 156: Time of up movement

This parameter determines the time needed for roller blinds to reach the top.

For modes with positioning value is set automatically during calibration, otherwise, it must be

set manually.

Size: 4 Byte, Default Value: 6000

Setting

1 - 90000 (0.01 – 900.00s, every 0.01s) – movement time

Parameter 157: Time of down movement

Description