FIBARO FGDW-002-2 Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sensor Keamanan FIBARO FGDW-002-2. FIBARO FGDW-002-2 16 halaman. Door/window sensor
Halaman Cetak#3: Adding/removing the device
Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device to the Z-Wave network:
1. Place the Door/Window Sensor 2 within the direct range of your
Z-Wave controller.
2. Set the main controller in (Security/non-Security Mode) add mode
(see the controller's manual).
3. Quickly, three times press one of the TMP buttons (while the other
button is pressed).
With cover closed
4. Wait for the adding process to end.
5. Successful adding will be confirmed by the Z-Wave controller's
message.
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device from the Z-Wave network:
1. Place the Door/Window Sensor 2 within the direct range of your
Z-Wave controller.
2. Set the main controller into remove mode (see the controller's
manual).
3. Quickly, three times press one of the TMP buttons (while the other
button is pressed).
With cover closed
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller's
message.
TMP
button
When attached to a surface
TMP
button
When attached to a surface
TMP
button
TMP
button
ADDInG/REMOVInG THE DEVICE
5
i
NOTE
Adding
in
Security
Mode must be per-
formed up to 2 meters
from the controller.
i
NOTE
In case of problems
with adding the de-
vice, please reset the
device and repeat the
adding procedure.