Fiber Instruments Sales Optical Talk Set Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Uji Fiber Instruments Sales Optical Talk Set. Fiber Instruments Sales Optical Talk Set 8 halaman.
Halaman Cetak7.0 Troubleshooting
Problems
Low voice
Low and not clear
voice
Output power
does not reach the
requirement
The output power
value is unstable
8.0 General Maintenance
•
Always keep the connector ports of your power meter clean.
•
Do not use APC (green) fiber connectors, otherwise, it will damage
the interface of detector that will greatly affect the performance of
the unit.
•
Try to use only the adaptors supplied.
•
Once not in use, make sure dust-proof cap is placed properly over
the optical ports.
•
Carefully plug in/out fiber connectors/adapters to avoid scratches
on the port of the power meter.
•
Perform regular cleanings on the optical port of power meter,
please clean with cotton swabs and/or alcohol properly.
4
Reasons
The voice
controller is turned
down
FC/SC connector is
not clean
1. FC/SC connector
are not clean
2. APC ferrules
cannot be used
1. The tester has
just turned on,
laser device still
not stabled.
2. The laser port is
dirty/dusty.
Solutions
Turn up the voice
controller
Clean the
connector use the
cotton swab.
1. Clean the
connector with
the cotton swab.
2. Use correct
connectors.
1.Open the tester,
and use it after
3 minis
2. Clean the laser
port