Sharp Carousel R-1514 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Oven Microwave Sharp Carousel R-1514. Sharp Carousel R-1514 40 halaman. Over the range stainless
Juga untuk Sharp Carousel R-1514: Brosur & Spesifikasi (8 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memasak (32 halaman), Brosur & Spesifikasi (5 halaman), Panduan Petunjuk Instalasi (9 halaman), Spesifikasi (2 halaman), Panduan Servis Tambahan (33 halaman), Panduan Memasak (32 halaman), Panduan Servis Tambahan (33 halaman)

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

8 VENTILATION SYSTEM (PREPARING OVEN FOR INSTALLATION)

This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type

required for your installation.

Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the

Charcoal Filter, which has already been installed in the oven.

Horizontal Exhaust — outside ventilation. Follow installation procedure (B).

Vertical Exhaust — outside ventilation. Follow installation procedure (C).

(A) RECIRCULATING: Non-Vented, Ductless Operation

The unit is shipped assembled for recirculating.

1. The Exhaust Damper Assembly 9 is not required for recirculating operation.

NOTE:

2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use.

3. The Charcoal Filter RK-240 is also sold as an accessory. See Page 14 for ordering information.

(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION

1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be

used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow

on the Fan Cover Bracket, as shown in Figure 7.

2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan

wiring.

3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 9 (A).

Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B).

4. Put the wire back into the cavity. See Figure 10.

Figure 7

Figure 9

(A) Rotate 180˚

(B)

Figure 8

Figure 10

Save fan cover bracket for

future instructions.