Sharp Aquos LC 42D65UT Panduan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk TV LCD Sharp Aquos LC 42D65UT. Sharp Aquos LC 42D65UT 47 halaman. Sharp flat panel television user manual
Halaman Cetak
Supplied Accessories
Make sure the following accessories are provided with the product.
Remote control unit
"AAA" size battery
( g 1)
Page 7
• Always use the AC cord supplied with the TV.
• AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult the following.
SHARP ELECTRONICS CORPORATION, LATIN AMERICA GROUP
6100 Blue Lagoon Drive, Suite 150, Miami, Florida 33126, U.S.A.
• To avoid scratching the frame or screen, please use a soft, lint free cloth for cleaning. Approved cleaning cloths are available
directly from Sharp in single (00Z-LCD-CLOTH) or triple (00Z-LCD-CLOTH-3) packs. Call 1-800-BE-SHARP for ordering, or
VISIT www.sharpusa.com/SharpDirect.
QUICK REFERENCE
Attaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Confi rm that there are 8 screws (4 short screws
and 4 long screws) and a hex key supplied with the
stand unit.
2 Attach the supporting post for the stand unit onto
the base using the box for the stand unit as shown
below.
•
The supporting post attaches to the base at an off-centered
location on the base. Be sure to attach the supporting post in
the direction indicated below and attach the stand to the TV
with the wider side of the base facing forward.
Forward
6
AC cord
( g 2)
( g 1)
Page 8
Page 7
Hex key
Long screws
Cable clamp ( g 1)
Cable tie ( g 1)
Page 7
1
3
Insert the stand into the openings on the bottom
of the TV.
2
Insert and tighten the 4 short screws into the 4
holes on the rear of the TV.
Short screws
2
Soft cushion
• To detach the stand, perform the steps in reverse order.
Stand unit
Operation manual
( g 1)
( g 1)
Page 6
Hex key
2
1
1