Sharp Aquos LC-19LE320E Panduan Pengoperasian - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk TV LCD Sharp Aquos LC-19LE320E. Sharp Aquos LC-19LE320E 32 halaman. Lcd colour television
Juga untuk Sharp Aquos LC-19LE320E: (Spanyol) Manual De Manejo (34 halaman)
Halaman Cetak
Connecting external devices
example of connectable devices
E VCR E DVD recorder
When using the SCart 2
E
Half SCART, which transmits S-Video or CVBS in, and
CVBS monitor out.
VCD / DVD
recorder
note
•
In cases when the decoder needs to receive a signal
from the TV, make sure to select the appropriate input
source.
•
Do not connect the decoder to the SCART 2.
•
You cannot connect the VCR with Decoder using a fully
wired SCART cable under the SCART 2 source.
Speaker / amplifier connection
Connecting an amplifier with digital audio
E
input / analogue audio input
Digital audio in
Speaker / amplifier
(COAXIAL)
connection
AUDIO IN
L
Audio cable
SCART cable
SCART 2
Digital audio cable
R
SPDIF OUT
inserting the Smartcard into the Ca module
In order to receive coded digital stations, a conditional
access module (CA module) and a Smartcard must be
inserted in the CI (Common Interface) slot of the TV.
The CA Module and the Smartcard are not supplied
accessories. They are usually available from your
dealer.
inserting the Smartcard into the Ca module
1�
Carefully insert the CA module in the CI slot
with the contact side forward.
2�
The logo on the CA module must be facing
outward from the rear of the TV.
note
•
It takes about 30 seconds to certify the license key
when you insert a Smartcard into the CI+ compatible
CA module for the first time. This process may fail when
there is no antenna input or you have never run "Auto
installation".
•
The CI+ compatible CA module sometimes upgrades
its firmware. You may not receive any TV images before
upgrading. You can only use the power button during
upgrading.
•
The CI+ compatible CA module does not allow you to
output any copy protected programmes using monitor
out.
•
If the TV displays an update confirmation message
for the Smartcard while receiving CI+ compatible
broadcasts, follow the screen prompts.
•
Make sure that the CA module is properly inserted.
Checking Ca module information
After inserting and activating the CA Module, make
sure the input source is tV.
1�
Press
menu on the remote control.
2�
Features > Common interface.
Go to
note
•
This menu is only available for digital stations.
•
The content of this menu depends on the provider of the
CA module.
module
General information on CA module displays.
menu
Adjustment parameters of each Smartcard displays.
enquiry
You can input numerical values such as passwords here.
25