Sharp Aquos LC-32LD166K Panduan Pengoperasian - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk TV LCD Sharp Aquos LC-32LD166K. Sharp Aquos LC-32LD166K 18 halaman. Sharp lcd colour television operation manual
Halaman Cetak
Using the remote control
Use the remote control unit by pointing it towards the
remote control sensor� Objects between the remote
control unit and sensor may block proper operation�
Remote control sensor
30º (5 m)
Horizontal & Vertical
• If you are not going to use the remote control for a long
time, remove the batteries to avoid damaging remote
control caused by chemical leakage�
Display the Menu Screen
Press MENU on the remote control to display the
menu screen�
Select an item by the remote control
Main Menu
Picture
Smart Picture
Picture
Backlight
Contrast
Sound
Brightness
Saturation
TV
Sharpness
Tint
Setup
Colour Temperature
16:9 Overscan
Parental
Advanced Video
Select
EXIT
RETURN
3
1�
Press
to select the desired menu�
2�
Press
to select / adjust the item to the desired
level� The new setting on the screen is applied
immediately�
3�
Press EXIT to return to the previous layer�
Exit the Menu Screen
Press EXIT or Menu to exit the menu screen�
Run the auto installation
Follow the onscreen instructions to select your
preferred Language, Country, and Location�
Daily operation
Turning on/off the power
Turn on the power by pressing the
Turn off the power by pressing again the
the TV�
Changing channels
Change channels by pressing P
(7 m)
Standby mode
0º
To standby mode
E
If the TV set is switched on, you can switch it to
standby mode by pressing B button on the remote
control�
Switching on from standby
E
To switch on from standby mode, press B button on
the remote control�
TV indicator status
1/2
Standard
90
90
50
NOTE
50
• If you are not going to use this TV for a long period of
10
0
time, be sure to remove the AC cord from the power
Normal
outlet�
On
• A small amount of electric power is still consumed even
OK
Access
when the power is turned off�
Selecting external video source
Once the connection is done, press b button to
display the Input Selection screen, and then press
source, and press with OK button to confirm�
Preparation and Watching TV
Status
B indicator
Off
Power off
Red
Standby
Blue
Power on
button to switch over to the appropriate external
button on the TV�
button on
button�
- 5