DIGISYNTHETIC DP45O Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat DIGISYNTHETIC DP45O. DIGISYNTHETIC DP45O 13 halaman. Professional power amplifier
Halaman Cetak5.3.3 Signal Limiting Circuit
This internal limiting circuit automatically reduce gain because of a significant deviation
between input and output signal flow, preventing occurrence of gross non-linearity
conditions inside the amplifier caused by overdrive, overload or defect, and keeps the
signal shape unaltered under any conditions. The circuit keep signal flow distortion
under 0.5%, and thus guarantees clean sound and effective speakon protection.
6. Specifications
All amplifier specifications apply to the following settings: Stereo mode with 8-ohm loads
and an input sensitivity of 32dB, unless otherwise specified.
Power Specification
Output Power:
The following specifications are guaranteed minimums for standard 1
kHz power. For more information, see the power matrix in Figures 3.1 through 3.2
(DIGISYNTHETICimum average power @ 0.1% THD +N).
CHANNEL 1
LEVEL CONTROL
LEVEL CONTROL
Fig.2.1 Front Panel Level Control
The following diagram illustrates the actions taken by the Thermal
Management System:
Load Impedance:
8ohms in Bridge-Mono and 4 to 8 ohms in Parallel-Mono mode.
Required AC Mains:
each unit's back panel. All models draw 90 Watts or less at idle.
DP450: (220/50Hz)
Draws up to 10 amps of current.
AC Connector:
An appropriate AC line cord and plug are provided. 110/220 VAC,
50Hz/60Hz units have a standard 3-wire, 15-amp grounded connector (NEMA 5-
15P).
Controls
Power:
A front panel rocker switch is used to turn the amplifier on and off.
Level
: A front panel rotary potentiometer for each channel is used to control the output
level.
CHANNEL 2
Safe with all types of loads. Rated at 4 to 8 ohms in Stereo, 4 to
Current, frequency and voltage requirements are provided on
Heatsink temperature
Temperature Protect Circuit (TPC)
90
c
Automatic
Out put the signal
c
80
°
At 75 C
c
70
60
c
60
DIGISYNTHETIC. fan speed
C
50
c
c
40
c
30
20
c
Min. fan speed,
c
10
TPC normal
c
0
Amplifier: DP Series
Fig.2.2 TPC
90
C
Mute the signal
80 C
TPC Limiter active
Fan speed
Page 9