DIGISYNTHETIC DSM 1043 Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Peralatan Perekaman DIGISYNTHETIC DSM 1043. DIGISYNTHETIC DSM 1043 10 halaman. Professional mixing console dsp

Halaman Cetak

6 EFFECT SECTION

28 REC OUT
This jack can be connected with cassette deck when recording the mixed
28
out.
29) AUX1.SUX2 SEND
Unbalance jack connectors for connection of monitors, either amplified or
for amplification; the output signal level is regulated by the Aux1.aux2
29
controls.
30) AUX1.AUX2 RET
30
Input connector allowing the output of the remote effect device to be
connected to the mixer.
31) AUX1.AIX2 SEND CONTROL
They regulate the general level of the monitor line signals received from
the input channels for sending to the monitor spedkers of the audio system
connected to the mixer by means of the AUX1. AUX2 outputs
32) PHANTOM LED .POWER LED.PFL LED
PHANTOM LED that lights up when push the phantom power switch,
31
power LED that leghts up when the power is on , PFL LED lights up
when the PFL switch is pressed.
33) HEADPHONE VOLUME CONTROL
Controls the level of the headphone listening volume.
34 )AUX1-2EFF
Controls the level of the EFFECTS signal to be send to the AUX1-2 SEND.
32
35) EFF1-2SEND
They regulate the general level of the effect line signals received from the
input channels for sending to the internal effect section.
36) PAN
33
Using by this control, you can adjust echo sound between left &right.
37) PFL
34
Allows headphone monitoring of the level of the EFF2 effect. The PFL (Pre
Fader Listen) function allows the level to be listened to before the action
of the volume control.
35
38) SUB1-2
Push the switch, the effect signal can to be the SUB1-2 fader.
36
39) MINA L-R
Push the switch, the effect signal can be main L-R fader.
40) EFFECT FADER
Control of the level of the effect1-2 signal level to be sent to the main, SUB
out outputs.
37
38
39
40
5