Sharp 20MR10 Panduan Servis - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Servis untuk TV Sharp 20MR10. Sharp 20MR10 26 halaman. Service manual
Halaman Cetak
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
1. The unit of resistance "ohm" is omitted.
(K=k =1000 , M=M )
2. All resistors are 1/10 watt, unless otherwise noted.
3. All capacitors are µF, unless otherwise noted.
(P=pF=µµF)
4. (G) indicates ±2% tolerance may be used.
5.
indicates line isolated ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000µ V B & W or Color
signal.
1.0
1.0
1.2
25
1160
220
1.4
105
WAVEFORM MEASUREMENT CONDITIONS:
1. Photographs taken on a standard gated color bar
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2.
waveforms are measured from point indicated to
chassis ground.)
!
This circuit diagram is a standard one, printed
circuits may be subject to change for product
improvement without prior notice.
WAVEFORMS
0.9
5.0
47
4.6
150
133
95
105
13
indicates waveform check points (See chart,
AND SHADED (
) COMPONENTS
= SAFETY RELATED PARTS.
MARK= X-RAY RELATED PARTS.
5.0
2.1
0.7
33
220
1.7
20MR10
1.0
39.0
0.7