Sharp 21G-FX10L Panduan Servis - Halaman 26
Jelajahi secara online atau unduh pdf Panduan Servis untuk TV Sharp 21G-FX10L. Sharp 21G-FX10L 50 halaman. Colour television
Halaman Cetak
CHAPTER 9.
E
Market
21G-FX10L
Service Manual
21G-FX10L
TV
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:
1. The unit of resistance "ohm" is omitted.
(K=k Ω =1000 Ω , M=M Ω )
2. All resistors are 1/16 watt, unless otherwise noted.
3. All capacitors are μ F, unless otherwise noted.
(P=pF= μμ F)
4. (G) indicates ± 2% tolerance may be used.
5.
indicates line isolated ground.
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connected
between points indicated and chassis ground, line
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.
2. All voltages measured with 1000 μ V B & W or Color
signal.
DESCRIPTION OF SCHEMATIC DIAGRAM
WAVEFORM MEASUREMENT CONDITIONS:
Photographs taken on a standard gated color bar
1.
signal, the tint setting adjusted for proper color. The
wave shapes at the red, green and blue cathodes of
the picture tube depend on the tint, color level and
picture control.
2.
indicates waveform check points (See chart,
waveforms are measured from point indicated to
chassis ground.)
AND SHADED (
= SAFETY RELATED PARTS.
MARK= X-RAY RELATED PARTS.
DRGANNES MARQUES
PIECES RELATIVES A LA SECURITE.
MARQUE
: PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
9 – 1
21G-FX10L
) COMPONENTS
ET HACHRES (
):