Sharp AQUOS CD-BA250 Panduan Pengoperasian - Halaman 29
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp AQUOS CD-BA250. Sharp AQUOS CD-BA250 32 halaman. Led backlight tv
Juga untuk Sharp AQUOS CD-BA250: Panduan Cepat (4 halaman), Panduan Pengoperasian (36 halaman)
Halaman Cetak
Troubleshooting Chart
Many potential "problems" can be resolved by the owner without calling a service
technician.
If something is wrong with this product, check the following before calling your autho-
rized SHARP dealer or service center.
„ General
Symptom
z The clock is not on time.
z Did a power failure occur? Reset the clock.
(Refer to page 15.)
z When a button is pressed, the unit
z Set this unit to the power stand-by mode and
does not respond.
then turn it back on.
z If the unit still malfunctions, reset it. (Refer to
step 3 under "If trouble occurs" on page 30.)
z No sound is heard.
z Is the volume level set to "0"?
z Are the headphones connected?
z Are the speaker wires disconnected?
„ CD player
Symptom
z Playback does not start.
z Is the disc loaded upside-down?
z Playback stops in the middle or is not
z Does the disc satisfy the standards?
performed properly.
z Is the disc distorted or scratched?
z Playback sounds are skipped, or
z Is the unit located near excessive vibrations?
stopped in the middle of a track.
z Is the disc very dirty?
z Has condensation formed inside the unit?
„ Tuner
Symptom
z Radio makes unusual noise con-
z Is the unit placed near the TV or computer?
secutively.
z Is the FM/AM loop antenna placed properly?
Move the AC power cord away from the an-
tenna if located near.
„ Cassette deck
z Cannot record.
z Cannot record tracks with proper
sound quality.
Possible cause
z Cannot erase completely.
z Sound skipping.
z Cannot hear treble.
z Sound fluctuation.
z Cannot remove the tape.
„ Remote control
Possible cause
z The remote control does not oper-
ate.
„ Condensation
Sudden temperature changes, storage or operation
in an extremely humid environment may cause con-
densation inside the cabinet (CD pickup, tape
Possible cause
heads, etc.) or on the transmitter on the remote con-
trol.
Condensation can cause the unit to malfunction. If
this happens, leave the power on with no disc (or
cassette) in the unit until normal playback is possible
(about 1 hour). Wipe off any condensation on the
transmitter with a soft cloth before operating the unit.
Symptom
Possible cause
z Is the erase-protection tab removed?
z Is it a normal tape? (You cannot record on a
metal or CrO tape.)
z Is there any slack?
z Is the tape stretched?
z Are the capstans, pinch rollers, or heads
dirty?
z If a power failure occurs during playback, the
heads remain engaged with the tape. Do not
open the compartment forcibly. Wait until
electricity resumes.
Symptom
Possible cause
z Is the AC power cord of the unit plugged in?
z Is the battery polarity respected?
z Are the batteries dead?
z Is the distance or angle incorrect?
z Does the remote control sensor receive
strong light?
00/12/4
CD-BA250(U)3.fm
29