Sharp AQUOS CD-BA250 Panduan Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp AQUOS CD-BA250. Sharp AQUOS CD-BA250 36 halaman. Led backlight tv
Juga untuk Sharp AQUOS CD-BA250: Panduan Pengoperasian (32 halaman), Panduan Cepat (4 halaman)
Halaman Cetak
Attaching the stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
1
Confirm the screws supplied with the TV.
Screws ( m 4)
(used in step 3)
2
Insert the stand base guide pins to
the stand holes on the rear of the
TV. (1)
• Make sure the symbol on the stand
base is parallel with the triangle
symbol located at the back of the TV.
3
Insert and tighten the 4 screws into the 4 holes
on the rear of the stand base. (2)
NOTE
• To detach the stand, perform the steps in reverse order.
• The TV position setting is set to 7˚ backward after attaching the stand.
• Do not remove the plastic wrap before attaching the stand base to protect it from scratches.
• The bottom area of the set (curvy area) must be beyond the table's edge to prevent the TV from damage.
Antenna connection
Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
Room antenna terminal
(75-ohm type)
NOTE
• Place the TV close to the AC outlet, and keep the power plug within reach.
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE AC
CORD CONNECTED.
• The illustration used throughout this manual are based on LC-32LE355X.
Antenna cable
(commercially available)
Screw driver
Soft cushion
Screw
Guide pin holes
To antenna terminal
Stand base
guide pins
Table edge
3