Sharp CD-BA2600 Panduan Pengoperasian - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-BA2600. Sharp CD-BA2600 32 halaman.
Juga untuk Sharp CD-BA2600: Panduan Cepat (4 halaman)

Halaman Cetak
Sharp CD-BA2600 Panduan Pengoperasian

Setting the Clock

In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the MEMO-
RY/SET button.
3
Press the TUNING/TIME (
or
) button to select 12-hour or 24-
hour display and then press the MEMORY/SET button.
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
Note that this can only be set when the unit is first installed or it has been reset.
(Refer to step 3 under "If trouble occurs" on page 30.)
4
Press the TUNING/TIME ( or ) button to adjust the hour and then
press the MEMORY/SET button.
z Press the TUNING/TIME (
or
) button once to advance the time by 1 hour.
Hold it down to advance continuously.
z When the 12-hour display is selected, "AM" will change automatically to "PM".
5
Press the TUNING/TIME (
or
) button to adjust the minutes and
then press the MEMORY/SET button.
z Press the TUNING/TIME (
or
) button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
z The hour will not advance even if minutes advance from "59" to "00".
z The clock begins counting from "0" seconds. (Seconds are not displayed.)
The time display will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning. If the time display is flashing, step 3
(for selecting the 12-hour or 24-hour display) will be skipped.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Perform to step 3 under "If trouble occurs" on
page 30 for details.]
2 Perform "Setting the Clock" from the beginning.
00/12/4
CD-BA250(U)2.fm
15