Sharp CD-DH790N Panduan Pengoperasian - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-DH790N. Sharp CD-DH790N 23 halaman. Sony stereo system user manual
Halaman Cetak
Timer and sleep operation (Remote control only)
Timer playback:
The unit turns on and plays the desired source (CD,
TUNER, USB, iPod, AUDIO IN, TAPE) at a preset time.
This unit has 2 types of timer: ONCE TIMER and DAILY
TIMER.
Once timer:
Once timer play works for one time only at a preset time.
Daily timer:
Daily timer play works at the same preset time every day.
For example, set the timer as a wake-up call every
morning.
Using the once timer and daily timer in combination:
For example, use the once timer to listen a radio program,
and use the daily timer to wake up.
1
Set the daily timer (pages 17 - 18).
2
Set the once timer (pages 17 - 18).
1 minute or more
Daily timer
Stop
Start
CD
USB
TAPE
Once timer
Start
■ Timer playback
Before setting timer:
● Check that the clock is set to the correct time (refer to
page 6). If it is not set, you cannot use the timer
function.
● For timer playback: Plug in USB or load discs or dock
iPod to be played.
1
Press the ON/STAND-BY button to turn the power on.
2
Press and hold the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "ONCE SET" or "DAILY SET", and press the
MEMORY button. Set the clock to the correct time if
"ONCE SET" or "DAILY SET" does not appear.
4
Within 10 seconds, press the
select "TIMER SET", and press the MEMORY button.
5
To adjust the hour, press the
then press the MEMORY button.
6
To adjust the minutes, press the
then press the MEMORY button.
7
Set the time to finish as in steps 5 and 6 above.
8
To select the timer playback source (CD, TUNER, USB,
iPod, TAPE or AUDIO IN), press the
Press the MEMORY button.
When you select the tuner, select a station by pressing
the
button. If a station has not been programed, "NO
PRESET" will be displayed and timer setting will be
canceled.
9
Adjust the volume using the VOLUME control, and then
press the MEMORY button. Do not turn the volume up
too high.
10
Press the ON/STAND-BY button to enter the power
stand-by mode. The "TIMER" indicator lights up and
Stop
the unit is ready for timer playback.
11
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the
preset volume. The " " indicator will blink during timer
playback.
The "DAILY" indicator will blink during timer playback.
E-17
or
button, and then press the MEMORY
M I NI C O M PO NE NT S YST EM
CD-DH790
POWER
POWER
ON/STAND-BY
ON/STAND-BY
AUDIO IN
or
button to
or
button to
or
button and
or
button and
or
button.
FUNCTION
FUNCTION
VOL
VOL
PUSH
PUSH
OPEN
OPEN