Sharp CD-ES600 Panduan Pengoperasian - Halaman 32
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-ES600. Sharp CD-ES600 36 halaman. Sharp mini component system operation manual cd-es600 ,cd-es66
Halaman Cetak
CD-ES600
CD-ES66
! Headphones
" Before plugging in or unplugging the headphones, reduce the vol-
ume.
" Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
" Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
32
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
! General
Symptom
" The clock is not set to the
" Did a power failure occur? Reset
correct time.
" When a button is pressed,
" Set the unit to the power stand-
the unit does not respond.
" If the unit still malfunctions, reset
" No sound is heard.
" Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires discon-
! CD player
Symptom
" Playback does not start.
" Is the disc loaded upside down?
" Playback stops in the mid-
" Does the disc satisfy the stan-
dle or is not performed
properly.
" Is the disc distorted or
" Playback sounds are
" Is the unit located near excessive
skipped, or stopped in the
middle of a track.
" Is the disc very dirty?
" Has condensation formed inside
Possible cause
the clock. (Refer to page 15.)
by mode and then turn it back on.
it. (Refer to page 33.)
nected?
Possible cause
dards?
scratched?
vibrations?
the unit?