Sharp CD-G10000 Panduan Pengoperasian - Halaman 41

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-G10000. Sharp CD-G10000 47 halaman. Mini component system

Headphones
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOL. control.

Troubleshooting chart

Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
Symptom
The clock is not set to the
Did a power failure occur? Reset
correct time.
the clock. (Refer to page 19.)
When a button is pressed,
Set the unit to the power stand-
the unit does not respond.
by mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 43.)
No sound is heard.
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires discon-
nected?
CD player
Symptom
Playback does not start.
Is the disc loaded upside down?
Playback stops in the mid-
Does the disc satisfy the stan-
dle or is not performed
dards?
properly.
Is the disc distorted or
scratched?
Playback sounds are
Is the unit located near excessive
skipped, or stopped in the
vibrations?
middle of a track.
Is the disc very dirty?
Has condensation formed inside
the unit?
CD-G10000
CP-G10000S
Possible cause
Possible cause
41