Sharp CD-MPX500H Panduan Pengoperasian - Halaman 43
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-MPX500H. Sharp CD-MPX500H 48 halaman. Mini component system
Halaman CetakHeadphones
Do not turn the volume on to full at switch on and listen to music
at moderate levels. Excessive sound pressure from earphones
and headphones can cause hearing loss.
Before plugging in or unplugging the headphones, reduce the vol-
ume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging
in
the
headphones
automatically. Adjust the volume using the VOLUME control.
disconnects
the
speakers
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom
The clock is not set to the
correct time.
When a button is pressed,
the unit does not respond.
No sound is heard.
CD player
Symptom
Playback does not start.
Playback stops in the
middle or is not performed
properly.
Playback sounds are
skipped, or stopped in the
middle of a track.
Possible cause
Did a power failure occur? Reset
the clock. (Refer to page 11.)
Set the unit to the power stand-
by mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 42.)
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires discon-
nected?
Possible cause
Is the disc loaded upside down?
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?
CD-MPX200H
CD-MPX200H3
CD-MPX500H
ENGLISH
E-40