Sharp AR M277 - B/W Laser - Copier Panduan Online - Halaman 33
Jelajahi secara online atau unduh pdf Panduan Online untuk Semua dalam Satu Printer Sharp AR M277 - B/W Laser - Copier. Sharp AR M277 - B/W Laser - Copier 36 halaman. Digital multifunctional system
Juga untuk Sharp AR M277 - B/W Laser - Copier: Panduan Pengaturan Perangkat Lunak (18 halaman)
Halaman Cetak
3
TROUBLESHOOTING
If a Notice Page is printed
If you find that a notice page has been printed at the end of a print job, the print data received from the computer has not been printed as
specified. Fix the problem as explained below and then try printing again.
If a Notice Page is printed
If the following Notice Page is printed, check your settings for the Staple function.
Stapling printed pages (when a finisher is installed)
****************************************************
Notice Page
****************************************************
The IMC memory full error had occurred,
a normal output was not able to be executed.
Please refer to the operation manual for
the solution method.
The IMC memory is used to store print data when the ROPM function is used. This memory is also used to store original image data
Note
in the copy mode. The percentage of IMC memory allocated to the printer function can be adjusted using a key operator program.
See "MEMORY FOR PRINTER" in the key operator's guide. The memory can be extended by adding commercially available
memory modules. For details, contact your SHARP dealer.
Disabling notice page printing
Notice page printing can be disabled using a key operator program (see "PROHIBIT NOTICE PAGE PRINTING" in the key operator's
guide).
CONTENTS
I N D E X
When the Staple function is not selected:
Disable the ROPM function by removing the checkmark from
"ROPM" in the "Configuration" tab of the printer driver setup
screen. (See "CONFIGURING THE PRINTER DRIVER" in the
software setup guide.) If you wish to use the ROPM function, set
the print quality to "Draft" or increase memory.
When the Staple function is selected:
Select "Draft" for the "Print quality" setting, or increase the value
set for "MEMORY FOR PRINTER" in the key operator programs.
If this does not solve the problem, add more IMC memory.
33