Sharp AR-5320 Panduan Servis - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Servis untuk Semua dalam Satu Printer Sharp AR-5320. Sharp AR-5320 20 halaman. Mono laser copier/printer
Juga untuk Sharp AR-5320: Panduan Pengaturan Perangkat Lunak (16 halaman), Brosur & Spesifikasi (4 halaman)

Halaman Cetak

Main

Sub

Contents

code

SPF jam counter display

Transfer current setting

Flash ROM program writing mode (Operating procedure)

Standby mode fusing fan RPM

setting

The SPF jam counter value is displayed. (Alternate display by 3 digits)When the [Interrupt] key is

pressed, the machine goes into the sub code input standby mode. When the [CA] key is pressed, the

simulation is terminated.

Used to set the transfer current for the front surface and that for the back surface. When this

simulation is executed, the current set value is displayed on the 7-seg display. Select the set value

with the zoom (Up/Down) keys and press the [START] key, and the set content is written into the

EEPROM and the machine goes into the sub code input standby mode. Press the [Mode select] key

to select each setting mode. At that time, the setup content is written into the EEPROM.

The set range is 90uA ~ 360uA in the increment of 10uA.

Display lamp

AE mode lamp

AE mode lamp & PHOTO mode lamp

AE & TEXT & PHOTO mode lamps

Small size paper must be Letter R (A4R) or smaller.

For the special size of tray, use the normal size width.

When this simulation is executed, "d" is displayed on the copy quantity display and the machine

enters the Flash ROM program writing mode. Use the writing tool on the PC to write the program.

During writing, the display is made as follows. After completion of downloading, turn OFF/ON the

power to reset.

Status

Download data reception

Data delete start

Data writing (Boot section)

Data writing (Program section)

Sum check

Completion of downloading

Error status

"*" in the error display indicates the error position.

Data receive error

FLASH ROM delete error

FLASH ROM write error (Boot section)

FLASH ROM write error (Program section)

Sum check error (Loader section)

Sum check error (Boot section)

When this simulation is executed, the currently set code number is displayed.

When [MODE SELECT] key is pressed, the normal setting and the high fusing temperature setting

are switched alternatively.

Enter the code number and press START key, and the number is written into the EEPROM and the

machine goes into the sub code entry standby mode.

Display lamp

AE mode lamp

Normal temperature control (190°C or less)

TEXT mode

Fusing temperature of 190°C or above

Code number

AR-5316/5320 SIMULATIONS 7-4

Details of operation

Normal size width: Front

Small size width: Front

Manual paper feed

Copy quantity display Pre-heat lamp

"d"

"OFF"

"*E"

Sum check error (Program section)

Sum check error (EEPROM section)

E2PROM verify error

Download data length error

Setting mode

Setting

Low speed rotation

High speed rotation

Setting mode

Ready lamp

OFF

Flash

OFF

Flash

OFF

Default

Low speed rotation

High speed rotation