Sharp SJ-194S Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Kulkas Sharp SJ-194S. Sharp SJ-194S 8 halaman.

Halaman Cetak

INSTALLATION

WARNING

Do not install the refrigerator in a damp or wet

■

location as this may cause damage to the

insulation. Condensation may also build on the

outer cabinet and cause rust.

Keep adequate ventilation space around the

refrigerator.

• The figure shows the minimum required space for

installing the refrigerator. The amount of space around

the refrigerator affects the amount of power

consumption.

• Insufficient spacing will decrease cooling efficiency

and increase energy consumption.

This may reduce the life of the unit and void warranty.

2. Using the front adjustable foot, ensure that the

refrigerator is positioned firmly and level on the floor.

3. Connect the power plug to a 230/240 volt. 10 amp.

power point.

NOTE

• Position your refrigerator so that the plug is accessible.

• Keep your refrigerator out of direct sunlight.

• Do not place next to a heat generating appliance.

• This refrigerator is designed for indoor use only, do not

place the unit on an unsealed surface.

OPERATION

Controlling temperatures

• FREEZER TEMP. CONTROL regulates the quantity of

cold air to the freezer.

• With FREEZER TEMP. CONTROL set to MAX, you may

need to adjust the REFRIGERATOR TEMP. CONTROL

to balance the temperatures.

• REFRIGERATOR TEMP. CONTROL controls the

compressor running time of the refrigeration system.

• MAX setting will result in colder temperature in both

(refrigerator and freezer) compartments.

EXTREME AMBIENT TEMPERATURES

During periods of extreme ambient temperatures

(e.g. less than 10°C, or more than 35°C)

you may find it necessary to rebalance the freezer and

refrigerator temperature controls accordingly.

90mm

60mm

Adjustable

foot

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.

If soapy water is used, wipe it off thoroughly with water.

Hints when making ice

1. Do not over fill the Ice cube trays;

otherwise the ice cubes will be

joined together when frozen.

2. When the ice cubes are made, turn

the lever clockwise to empty the ice

into the Ice cube box.

NOTE:

To prevent damage to the Ice cube

box, do not make ice in the Ice cube

box.

Deodorizing unit

A deodorizing catalyst is installed on the routes of cold air.

No operation or cleaning is required.

Defrosting

Defrosting is fully automatic due to a unique energy saving

system.

60mm

194S,222S

308S

244S type

339S type

970mm

1065mm

1145mm

1221mm

Lever

Ice cube box