Sharp SJ-2047-GY Panduan Servis - Halaman 19
Jelajahi secara online atau unduh pdf Panduan Servis untuk Kulkas Sharp SJ-2047-GY. Sharp SJ-2047-GY 36 halaman.
![Sharp SJ-2047-GY Panduan Servis](/uploads/products/server2/5051216/5051216.png)
MODIFICATION PROCEDURE OF THE DOOR OPEN SIDE
It is possible to change the door to left side opening.
To modify the door to left side opening, REFRIGERATOR HINGE KITS (for left side opening) SJ-L838LD (optional item )is necessary.
These kits are used to change the refrigerator doors from right to left opening.
if you wish to change the door to left opening for some reason, such as restricted installation
space, ask your authorized service agent for this modification.
Parts list
Bottom hinge L
A
B
F
G
Door hole cover
Tools required
Phillips and slotted screwdrivers
Drill bit (
3.8 mm)
Socket wrench or spanner (8 mm) :The socket wrench or spanner is used to detach and attach hinges.
Caution
Always disconnect the power plug from the wall outlet before performing work.
Caution should be taken when handling the doors.
These are heavy and could cause personal injury if mishandled.
Always tighten screws securely. May cause personal injury if door becomes unlatched and falls.
Reattach doors paying careful attention to the door alignment. Failure to fit the door
correctly might cause the cool air to leak out and lower the cooling performance.
Fitting Instruction
1
Preparation/Removing Doors
1. Remove Evaporating pan cover, Upper hinge cover, and Top cover.
(Carefully remove Upper hinge cover using a screwdriver, making sure that the door is not damaged.)
2. Remove Upper hinge and Spacer, and detach Upper door by lifting off the center hinge.
3. Remove Center hinge and detach Lower door by lifting off the bottom hinge. Remove the 2 Hole caps, replace them on
the screw holes of the removed center hinge, then screw in G (screw and cover) in the center hole.
4. Remove Bottom hinge. Remove the 3 screws on the left side, then install them in the screw holes of Bottom hinge.
1
Stopper spring L
Stopper spring L
C
(for lower door)
(for upper door)
H
Screw and Cover
Silicon grease
1
2
1
3
3
G
3
4
4
by SJ-L838LD OPERATION MANUAL
Select the same color as the refrigerator exterior.
Door cap cover
D
(for upper door)
Screw cap for handle
J
(Spare)
G
2
3
19
Door cap cover
E
(for lower door)
1
Figure M-1
SJ-2047
SJ-2050
SJ-2060