Sharp SJ-WP331T Panduan Pengoperasian - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Kulkas Sharp SJ-WP331T. Sharp SJ-WP331T 24 halaman.
INSTALLATION
WARNING
■
Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
•
The figure shows the minimum required space for
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
•
By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
•
If using the refrigerator in the smaller space dimension
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
90mm
or more
60mm
60mm
or more
or more
Free standing type
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
Clip the foot cover (supplied inside the refrigerator
compartment) in position in front of the two adjustable
feet.
NOTE
•
Position your refrigerator so that the plug is accessible.
•
Keep your refrigerator out of direct sunlight.
•
Do not place next to heat generating appliance.
•
Do not place directly on the ground.
Provide suitable stand.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
16
60mm
or more
1350mm
Adjustable foot
Foot cover
Before transporting
•
Wipe up water in the evaporating pan.
Before wiping up the water, wait more than 1 hour after
pulling out the plug because refrigeration cycle equipment
is extremely hot.
(The evaporating pan is located on the rear of the product.)
NOTE
•
Do not bend or damage the ductwork located on the inside of
the evaporating pan. It may cause failure.
When transporting
•
The casters allow the refrigerator to move and forth.
•
Carry the refrigerator by holding the handles located on
the rear and bottom.
Casters
(4 pcs.)
When the door is heavy to open
When one side door is heavy
•
When the left side is heavy, lower the right side adjustable
foot.
(Until the opposite side adjustable foot is slightly off-ground.)
Heavy
•
When the right side is heavy, lower the left side adjustable
foot.
When both sides are heavy
•
When the refrigerator is tilted backwards insert a wooden
board (with relatively large width), etc. between the rear of
the refrigerator and the floor to adjust the tilting.
Front
Evaporating pan
rear
bottom
Adjustable foot
Back
A wooden board
(with relatively large
width)