Sharp SJ-X44GP Panduan Pengoperasian - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Kulkas Sharp SJ-X44GP. Sharp SJ-X44GP 20 halaman.
Halaman Cetak
INSTALLATION
WARNING
■ Do not install the refrigerator in a damp or wet
location. It may cause the damage to the insulation
and a leak. Dew may also appear on the outer
cabinet and it causes rust.
■ In order to prevent electric shock, connect the earth
pin of the plug to the earth terminal properly.
1
Keep adequate ventilation space around the refrigerator.
The figure shows the minimum required space for
●
installing the refrigerator. The measurement condition
of power consumption is conducted under a different
space dimension.
●
By keeping greater space, the refrigerator may be
operated under a less amount of power consumption.
●
If using the refrigerator in the smaller space dimension
than the below figure, it may cause the temperature
rise in the unit, loud noise and failure.
60 mm
or more
●
The space between the rear of the refrigerator and
the wall should be 60 mm or more and less than
75 mm. If the space is wider than 75 mm, you may
get injured by touching compressor and its peripheral
parts which are extremely hot during the operation.
Overall space required in use
2
Use the two front Adjustable feet to place the refrigerator
fl atly and fi rmly on the fl oor.
12
SJ-XP400PG_EN.indd Sec1:12
SJ-XP400PG_EN.indd Sec1:12
90 mm
or more
60 mm
or more
1160 mm
Adjustable foot
3
Remove the 2 screws of the lower part of the cabinet
and use these screws to set the foot cover. (At fi rst, the
foot cover is inside the refrigerator compartment.)
Foot cover
NOTE
●
Place your refrigerator to access the plug.
●
Keep your refrigerator out of direct sunlight and do not
place next to heat generating appliance.
Do not place your refrigerator directly on the ground.
●
Provide suitable stand.
To insert the power plug when the door is opened, door
●
alarm sounds but it is not abnormal. This sound stops
when closing the door.
When transporting
●
The casters allow the refrigerator to move back and forth.
●
Carry the refrigerator by holding the handles located on
the rear and the bottom.
rear
Casters (2 pc)
●
Wipe up water in the evaporating pan. Before wiping
up the water, wait more than 1 hour after pulling out the
plug because refrigeration cycle equipment is extremely
hot. (The evaporating pan is located on the rear of the
product.)
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Free standing type
Screw (2 screws)
bottom
Evaporating pan
27/11/2014 13:37:37
27/11/2014 13:37:37