Sharp SJG2254FS Panduan Pengoperasian & Petunjuk Pemasangan - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengoperasian & Petunjuk Pemasangan untuk Kulkas Sharp SJG2254FS. Sharp SJG2254FS 24 halaman.
![Sharp SJG2254FS Panduan Pengoperasian & Petunjuk Pemasangan](/uploads/products/server2/5055122/5055122.jpg)
INSTALLATION INSTRUCTIONS
CONNECTING THE WATER LINE
Water line installation kits are available as an additional
accessory from your dealer or at a local hardware store.
1. Shut off the main water supply line.
2. Install a shut-off valve and water line 1/4" x 1/4" compression
thread (UNS 7/16-24), accessible with product in place. Refer
to local code and instructions with water line installation kit
(not included).
3. Connect the newly installed water supply line (B) to the
refrigerator water inlet connector (A), tighten using tool.
See Figure 17.
4. Gently tug on the water supply line to ensure a proper fit and
risk of damage when pulling or pushing the unit for cleaning.
5. Turn main water back on and check for leaks.
6. After connecting the water line, please flush one gallon of
water through the filter before drinking or using the water
from your refrigerator. (Flush approximately 5 minutes.) To
flush, press a large glass or cup against the water dispenser
lever. Fill the glass, then empty it. Repeat until you dispense
about one gallon of water.
B
Figure 17
INSTALLING DOOR HANDLES
Precautions shall be taken to prevent handle falling off and
causing any personal injury.
LIST OF TOOLS TO BE PROVIDED BY THE USER
Phillips screwdriver
Allen wrench
INSTALLATION PROCEDURES
1. Take out bolt 1 from accessory bag, then use Phillips
screwdriver to secure the bolt 1 into the bolt hole 2 of
refrigerator doors. See Figure 18.
2. Attach the handle of the door through the bolt hole 1 and
make sure that the handle makes contact to the door surface
closely.. See Figure 18.
A
12
3. Attach the handle by rotating the handle screw 3 clockwise
until it stops to the end, gently shake the handle to ensure it
has been attached securely.
4. Put the screw hole cap 4 on the handle screw hole to
complete this installation.
Note: the screw hole cap is not removable once applied.
Figure 18
Figure 19