Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector Panduan Pengoperasian - Halaman 35
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Proyektor Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector. Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector 49 halaman. Colour inkjet printer
Juga untuk Sharp AJ-1800 - Notevision PG-M10X XGA DLP Projector: Panduan Pengoperasian (49 halaman), Informasi Dasar & Persiapan (10 halaman), Panduan Pengoperasian (47 halaman)
Halaman Cetak
Auto Source Settings
With this function, the unit is automatically detecting the
input signal.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "SETUP".
2
Use the cursor
SOURCE", then use the cursor
to set "ON" or "OFF".
ON:
All input signals are detected.
OFF: Remote control VIDEO button:
Video and S-video are detected.
Remote control COMPUTER button:
RGB and YP
P
B
Main unit INPUT SELECT button:
All input signals are detected individually.
Selecting a Projection Format
If the projection format is not correctly set in accordance
with the installation conditions, images may be projected
reversed, vertically, or horizontally.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
keys to select "SETUP".
2
When "SETUP" menu is displayed, use the
cursor
/
keys to select "PROJECTION",
then press the ENTER button.
3
Use the cursor
projection format in accordance with the set
conditions.
The setting items will change as shown below each
time a key is pressed.
⇔
NORMAL
REVERSED VERTICALLY ⇔ REVERSED HORIZONTALLY
• The unit cannot be installed to the ceiling.
• Be sure to always leave a space of minimally 20 cm (7
between the unit and surrounding obstructions.
• Do not use an installation stand made of material that is not
heat-resistant.
• During an earthquake or when a child climbs on top of or
hangs from the stand, the unit may fall. Use a wall or a post
as a measure to prevent the unit from falling.
/
/
keys to select "AUTO
/
keys
signals are detected.
R
/
/
keys to select a
VERTICALLY+HORIZONTALLY
Using the Power Saving Function
When there is no signal input for a period of 5 min. or more,
the power is automatically turned off and standby status is
activated.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
buttons to select "SETUP".
2
When "SETUP" menu is displayed, use the
cursor
OFF".
3
Use the cursor
Saving to "ON" or "OFF".
7
/
")
8
Initial Settings
/
keys to select "AUTO POWER
/
keys to set Power
To close the menu
Press the R-CLICK/EXIT button.
/
33