Sharp XG-V10XU - Conference Series XGA LCD Projector Panduan Konfigurasi Jaringan - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Konfigurasi Jaringan untuk Proyektor Sharp XG-V10XU - Conference Series XGA LCD Projector. Sharp XG-V10XU - Conference Series XGA LCD Projector 19 halaman. How to connect to a network
Juga untuk Sharp XG-V10XU - Conference Series XGA LCD Projector: Panduan Referensi Cepat (2 halaman)
Halaman Cetak
When installing the expansion cards you must do the following:
1.) Shut projector Off.
2.) Remove the three screws from expansion plate cover. (Refer to Figure A)
3.) Remove (4) four screws that secure the RF shield (Refer to Figure B)
NOTE: Number 2 - Only needs to be done if expansion slot is used for first time.
4.) Remove the cover plate from the optional expansion board that will be installed into the slot.
5.) Insert the expansion board into the connector (Refer to Figure C)
6.) Secure the expansion cover to the board.
Expansion Board Installation
Expansion Slot Closed (with cover)
FIG. A
Screws that secure Expansion Plate cover (Fig A).
3
10/16/2001
L:\tekcentr\CACTrain\SPS_ntwk