Shimano Ultegra 6770 Series Manual - Halaman 21
Jelajahi secara online atau unduh pdf Manual untuk Sepeda Shimano Ultegra 6770 Series. Shimano Ultegra 6770 Series 24 halaman.
Halaman Cetak
4.
Remove the two switch unit fixing screws, and then remove the switches and the
switch springs. The bracket unit and the lever unit can then be disassembled.
Switch unit fixing screws
(#T5 TORX®)
TORX is a registered trademark of Camcar LLC.
$ Assembly of the switch unit
1.
Check that the buttons are attached to the springs, and then place the switch
springs into the holes in the switch unit setting plate.
2.
Place the switch unit against the mounting surface of the switch unit setting plate.
40
DURA-ACE Grease
(Y-04110000)
Apply grease
Switch springs
3.
Press the switch unit by hand so that the switch springs go
into the grooves in the buttons, and then push the shifting
switches (X and Y) in as far as they will go.
4.
Make a gap between the switch unit and the switch unit
setting plate and check that the end of the rubber on the
switch unit is on the button.
5.
Return the switch unit to the setting position for the switch
unit setting plate, and while pressing it by hand, operate
the shifting switches (X and Y) once more and check that
the switches turn on. Install the switch using the switch unit
fixing screws.
Tightening torque:
0.18 N·m {1.5 in. lbs.}
$ Assembly of the bracket unit and lever unit
1.
Assemble the bracket unit and the lever unit,
and then attach the return spring.
Switch unit
Shifting switches (X/Y)
41