Accutone Aquarius Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Headset Accutone Aquarius. Accutone Aquarius 4 halaman. In-ear headsets

Halaman Cetak

In order to prevent damage to your hearing,

the middle

and the volume on your mobile phone/audio device to the lowest before

inserting the headset to your ears. Slowly increase the audio volume for optimal

performance.

Listening at high volume levels for any prolonged period of time will cause

permanent and irreparable damage to your hearing.

NEVER insert the earplugs into your ears without the silicon/memory foam earbuds,

as it may cause infections or injury to your ear canals.

Try the various sizes of silicon earbuds for the perfect fit, but remove them from your

ears slowly and carefully to avoid them from coming off and staying in your ears.

NEVER insert the earbuds too deep into your ears!!!

Noise-isolation headsets prevents most sounds from the surrounding,

the headset during driving

or in situations where your attention is required.

Different In-Ear Headset model comes with slightly different accessories, but

generally the following accessories are included.

3x pairs of

silicon

earbuds

A pair of

memory foam

earbuds

nokia

phone converter

1x accutone

cable winder

1x headset leatherette

headset carrying case

ALWAYS set the volume control dial to

do not wear

Most In-Ear Headsets from Accutone comes with three different sizes of silicon

earbuds and a special-made memory foam earbuds. To replace an earbud, gently

twist and pull the bud from the nozzle and insert the replacement as shown above.

From time to time, if you notice a slight deterioration in sound quality, it may be a

result of obstruction from your ear-wax build-up.

cleanser to clean the nozzle as this will damage the headset.

Remove the earbud from its nozzle as shown in the above section, use a standard

small-size cotton swab to gently wipe the nozzle clean, do not apply too much

force when cleaning so to avoid pushing the ear-wax into the nozzle chamber.

Before inserting a memory foam

earbud in your ear, squeeze and

gently twist it to the smallest size

and allow it to slowly regain its

form inside your ear.

Once the memory foam regain its

size (takes about 10 seconds) it

will have molded with the shape of

your ear canal forming a perfect fit.

Do not use water

or any liquid